Sail Dive Fish
Life on the water
Menu Close
  • Home
  • Find Sooner
  • Photos
  • About Me
  • Boat One (Gudgeon)
    • About Gudgeon
    • Projects
      • LiFePo4 Battery Install
      • Porthole Replacement
      • ICOM 802 SSB Install
      • Autopilot Install
      • Mast Wiring Refit
      • Dickinson Diesel Install
      • Hebridean Construction
      • Yanmar 2QM20
  • The Start
  • Contact

gudgeon

Finishing Spinnaker Track

August 22, 2015Matt 1 Comment

Its finally done, after several weeks of sweat, blood and lost pieces overboard. Thanks to the Nancy Blackett crew for winching me up and down the damn mast, and Billy and John for the help hanging out and making dick… Continue reading →

Maintenance gudgeon, hunter 36, spinnaker pole, spinnaker track

Getting ready for a 12 day trip

August 20, 2015Matt Leave a comment

Next week I head off for almost two weeks. I plan to go down to Tacoma/Seattle to see some friends, head up to the islands and bum around there for a week and then head back down to Seattle to… Continue reading →

Maintenance engine, gelcoat, gudgeon, hot water heater, hunter 36, spinnaker, track

Organisation

August 14, 2015Matt Leave a comment

I’m in the middle of installing my spinnaker track, but took a break to do a couple of small tasks that have been bugging me for a while First of all, I needed to declutter the decks – currently there… Continue reading →

Maintenance gudgeon, hunter 36, mounts, organistion, stanchion

Throttle adjustment

August 13, 2015Matt 2 Comments

On my pedestal, I could push the throttle to around 2600 RPMs under load, but it always went down to ~2100RPM. I’d always assumed this was by design, but apparently not! So I firstly took the compass off and looked… Continue reading →

Maintenance 2qm20, engine, gudgeon, hunter 36

Bellingham Trip

August 10, 2015Matt 4 Comments

This weekend I went to Bellingham, it was my friend Elyese’s school reunion and it sounded like a good excuse for a sail, so I said I’d pick her up from Orcas island and head to Bellingham. Click on the… Continue reading →

Sailing, Uncategorized anchor, bellingham, gudgeon, hunter 36, sailing, san juans, trip

Installing a New Found Metals porthole

August 4, 2015Matt 4 Comments

If you follow this blog somewhat regularly and have a good memory, you will remember me bitching about a leak above the nav table. I thought this was a leaky porthole, so I ordered a new one from New Found… Continue reading →

Maintenance, Porthole Replacement force 10, gudgeon, hunter 36, new found metals, nfm, oven, porthole, propane

Mast Climbin’

July 31, 2015Matt Leave a comment

I needed to go up the mast to a) rerun the spreader halyard for my courtesy/quarantine flag that I stupidly had let come off b) rerun the halyard for the spinnaker (and more importantly, the hammock) which I had stupidly… Continue reading →

Maintenance climbing mast, gudgeon, hunter 36, mast

Facebook page

July 28, 2015Matt Leave a comment

Iama posted on 30/07/2015, as alctel I set up a facebook page for the blog, so updates to it won’t clutter up my wall. There is a button on the left that you can click to ‘like’ the page  … Continue reading →

Uncategorized gudgeon, hunter 36

Post navigation

← Older Articles
Newer Articles →

Past Posts

Picture Feed

Follow on Instagram

Archives

© 2026 Sail Dive Fish. All rights reserved.
Fashionista by aThemes