Last thing to do was run the wires into the cabin from the mast.

First I cut a hole in the base of the mast. I couldn’t find anything that would fit (noone makes a damn 1 1/4″ pipe with a flange apparently) so I found a sink drain

wpid-wp-1429508741346.jpg

 

I then dremled the inside out, and then drilled 4 holes in it

wpid-wp-1429508741654.jpg

wpid-wp-1429508741600.jpg

 

I then sanded down the sharp nubbins, drilled/tapped a few holes in the mast and attached it

wpid-wp-1429508742337.jpg

 

For the entry into the cabin I drilled a hole

wpid-wp-1429508743645.jpg

 

I then sealed the inside with thickened epoxy

wpid-wp-1429508742837.jpg

 

and installed thru-hull

wpid-wp-1429508743598.jpg

 

And last thing to do was to run a hole from mast to thru-hull

wpid-wp-1429508742552.jpg

Ta-da! Done.

This is what it looks like inside

wpid-wp-1429546485169.jpg

 

Now to wire the other ends. Ughhhhhhh

Liked it? Take a second to support Matt on Patreon!
Become a patron at Patreon!