After a few weeks off over the christmas holiday period, it was time to get back on the ol’ windvane horse and once again cover the inside of my cabin with tiny razor sharp pieces of metal.

First up:

 

Piece 2 

This piece was described as ‘tricky’ in the plans, and with good reason. It was a piece cut out of a bar, with a couple of diagonals meaning keeping to a straight line was a lot harder. It also had a cut that didn’t go all the way through.

I decided to orientate the bar vertically with a guide next to it and cut down

wp-1452788669161.jpg

leading to

wp-1452788706730.jpg

I then had to cut the other way, like

wp-1452788714692.jpg

Ending up with

wp-1452788689640.jpg

Then it was time to drill the holes.

A problem I ran into was that… well ok. Not really a problem I ran into, more that I buggered it up a bit. The plan uses a protractor to make sure you have the right angle – I didn’t use that and instead just tried to measure the top and bottom and cut from there. With predictable results – it was wrong. Also, the bottom cut is a bit wonky. Sigh. Use a protractor kids!

This meant I had to work out where the holes were and use the same reference point as on the plans. As both the left side and the top were untouched by my meddling, I used those to measure the holes. I think it will still work out just fine, there is only a mm or two difference in the piece size and the holes are all accurate

Testing the holes to make sure they are in the correct location

 

wp-1452788725554.jpg

The final product

wp-1452788731426.jpg

 

Piece 15

This piece is a bit different from the bog standard ‘drill hole in bar, cut bar, look impressed with self’ routine of most of the other parts. It consists of a small tube with a hole in it. I need to drill out the centre of the tube a bit larger so that I can fit a tap in and thread the inside

The tube

wp-1452788695221.jpg

Drilling a hole down centre

wp-1452788746737.jpg

Once that was done I had to tap dat ass the hole

wp-1452788752018.jpg

Next step was to cut down the screws that would go in there to form the ‘axle’. Before on left, after on right. I had to also cut a slot in the top of the cut down screw to allow me to tighten  them.

wp-1452788767276.jpg

I also sanded down a portion on both sides of the tube so I can grip it with a wrench

wp-1452788762887.jpg

The finished part (screws not screwed in the whole way)

wp-1452788770882.jpg

Liked it? Take a second to support Matt on Patreon!
Become a patron at Patreon!